Logview/Charging

Link to project Drones team page.

Link to userpage: Andyn6361.

Things to consider before using Logview
Do you have the VPS driver installed?

Did you restart the computer once the VPS driver was successfully installed?

Did you installed Logview?

If you did not do one of the checklists, please refer to the Logview Installation tutorial.

Checklist
Make sure the computer has recognized the usb cord connected to the dual power unit. Steps to check so is below:

1. Click start window

2. Go to devices and printers

3. Scroll down to unspecified. If USB to UART Bridge shows up under unspecified, the computer has recognized the dual power unit.

Connection Procedures
1. Find the suitable adapter to connect the battery to the dual power unit.

4. Connect the adapter of the battery to the white board according to the amount of teeth the adapter has.

Charging Procedures
1. Open up Logview and turn on the dual power unit once you have connected the battery to the dual power unit.

2. When the dual power unit is turned on, it will pop up Program Settings. Choose the right battery type being used. In our project, Lithium-Polymer battery is being tested so LiPo Batt is chosen. To choose a type of battery, press the start button.