MakerBot/How to Change the Wire of the Makerbot

Procedure to Change the wire of the Makebot

 * 1. Choose a Computer that is near the makerbot. Near makerbot.jpg
 * 2. Plug in the USB cord to the nearest computer.
 * 3. Turn the Makerbot on. Turn_on.jpg
 * 4. Go to start.
 * 5. In the search toolbar type "ReplicatorG"
 * 6. Open ReplicatorG Repliacto rg.jpg
 * 7. Click on the bottom to connect the Replicator to the Makerbot
 * 8. Click on Machine
 * 9. Go into Serial Port and Check if ReplicatorG is in "COM6"
 * 10. Go into Driver and Check that the machine is any of the "Cupcake options"
 * 11. Open Control Panel
 * 12. In the "target temperature" type "180" (Wait for the "Current temperature" to reach "180").
 * 13. Remove the screw from the printing head.Remove screw.jpg
 * 14. Raise the printing head so that one can pull out easily the wire.
 * 15. Pull out the wire.
 * 16. Put the new wire into the printing head.
 * 17: Put the screw back.
 * 18: Go into control panel in the "target temperature" type "0" (Wait for the "Current temperature" to reach "180").
 * 19 One can safety turn out the Makerbot.