Power Supply Testing/Tutorial to drill holes on the power supply shield


 * 1. Remove the power supply shield Power supply shield.JPG
 * 2. Put the power supply shield on the vise grip Shield in the grip.JPG
 * 3. Get a cup of oil. Oil.JPGCup of water.JPG
 * 4. Put a small drill bit in the drill. Adjust it so that is tight. Dip it in the cup of oil.
 * 5. Start drilling until one makes a hole. Small hole.JPG
 * 6. Change the drill bit. Increase the size. Dip it in oil
 * 7. Start drilling a bigger hole. Bigger hole.JPG
 * 8. Change the drill bit. Increase the size. Dip it in oil
 * 9. Start drilling bigger hole than previous one. Even bigger hole.JPG
 * 10. Change the drill bit. Increase the size. Dip it in oil
 * 11. Make the last hole (the hole should be as big to fit the bin post) Final hole.JPG
 * 12. Put the bin post Put the bin post.JPG
 * 13. Repeat steps 4-12 four more times to make the five holes. 5 bin post.JPG