Printing with double stick tape

Hello and welcome
If you are reading this, I assume you are either grading me, or trying to print with a piece of double side sticky tape to prevent the raft/base of the object from curling.

Prerequisites
-The printer must function normally, and more specifically the build platform should be level.

-have time enough to watch the first two layers complete.

-The double sided tape must be laid down properly

The problem
The print head will be too close to the new build platform covered with the sticky tape, and will result in a slightly messier product, or have the print head brush against the sticky, which slows down the printer, gets gunk on the head, and could ultimately jam the printer.

The solution
I used tools to weigh down the build platform by about .05mm