Resistor Reduction

This is a techniques for dealing with more complex circuit arrangements. Consider this problem: Based on what we have learned in the previous lectures this circuit is solvable. All we have to do is follow the reduction algorithm:
 * 1 If any two or more resistors are in series combine them together and then replace it with an equivalent resistance.
 * 2 If any two or more resistors are in parallel combine them together and then replace it with an equivalent resistance.
 * 3 Continue doing this until you are left with only one resistor.
 * 4 Solve for the source current/voltage (whichever is unknown)
 * 5 systematically unwrap the circuit solving as you go along.

First example
Lets go through this example assume we want to know the current through each resistor given that R1=5ohms, R2= 20ohms, R3=20 ohms, and the source is producing 20 volts:
 * Step 1 Can not be done because there are no series resistors
 * Step 2 Can be done R1 can be combined with R2 to make an effective resistance. R1|R2 is a way of saying R1 in parallel with R2. In this case its is equal to 4 ohms: [[Image:Reduction circuit 2.PNG]]
 * Step 3 Well were not down to one resistor so we start again we combine the series resistors and get a 24 ohm equivalent resistance.
 * Step 4 So we know the voltage and the equivalent resistance lets calculate the current. By V=IR we get 5/6 amps.
 * step 5 Now we start to expand the circuit
 * Since we know the current for the combined resistance and the other resistor is in series we know the current through R3 is equal to 5/6 Amps.
 * Step 5 now we unwind the circuit completely and get the final result
 * V=IR, V=(5/6)(4)=20/6. So R1's current is equal to 20/6 divided by 5 which is 2/3 amps. And R2 is 20/6 divided by 20 which is equal to 1/6.

Review
So we see the goal of the technique. We can apply it to any number of circuit problems. Be forewarned this is a hard techniques to master. It is recommend that the student goes through many examples. Remember the basic steps. Combine all the resistors into one resistor. Solve for the current/voltage of that one resistor and then unreduce the circuit solving for each resistor along the way.