Stormwater harvesting and management/Groundwater recharge/Bunds



Bunds (also called teras) are small barriers to runoff coming from external catchments (and possibly to a field where crops are to be grown). Bunds slow down water sheet flow on the ground surface and encourage infiltration (groundwater recharge) and soil moisture. There are different types of bunds. A rectangular type, where land is "bunded" on three sides, with the fourth side left open to capture runoff from an elevated area and a contour type, where bunds are created in rows along the contour of a hillside. The bunds consist of small stone or earthen walls. A small channel on the inside of the bunds is made to let the water run along. Excess water drains along the tips of the outer arms (rectangular type). These spillways may improve the efficiency and reduce maintenance costs of the teras. The base bund can be 50-300 meters long, while the arms are usually 20-100 meters long. Bunds are not generally built to eventually extract water, but rather to add soil moisture or contribute to groundwater recharge.

Bund design has to be adjusted according to local conditions. They can vary in design and include non-enclosed systems (e.g. trapezoidal bunds where water escapes around the edges), and enclosed systems (e.g. bunded fields where water enters via a channel and escapes from a spillway in the bund once the field is flooded). In certain site-specific examples, they are used to create small artificial glaciers which helps release melt water slowly, so as to adjust to short sowing seasons.

In West Africa the technology is widely used in valley bottoms.

Suitable conditions
1. Clay areas – bunds made from soil with high clay content develop leaks through pipes in the bund structure which form due to cracks when it dries. 2. Proximity to large water courses. 3. Sites needing extensive leveling.
 * Locate bunds in natural runoff areas, preferably in sites already shaped by topography – indicators include seeing where water flows during flood times, and soil / vegetation types. The key is to approach each site individually and to work with natural topographical features – experience in the area will influence the design.
 * Avoid the following areas:
 * Soil in vicinity needs to have sufficient infiltration capacity.
 * Ideally the slope should not be greater than 1.5% otherwise earthworks get prohibitive.
 * For artificial glaciers, altitude needs to be over 4,600 metres.
 * Foothill areas with high intensity and short duration rainfall with between 50 and 400 mm rainfall annually.
 * Catchments are typically 2 to 3 times the size of cultivated areas in (semi-) arid regions.

Drought
Effects of drought: Lower crop yields. Underlying causes of effects: Less water to crops from flooding. To increase resiliency of WASH system: Drought-resistant & fast-growing crops; Diversify livelihoods of farmers.

More information on managing drought: Resilient WASH systems in drought-prone areas.

Floods
When a region with bunds floods, strengthen the existing bunds by raising them several feet, otherwise breaches are possible. This is especially important when bunds are used to protect crops or urban/residential areas.

Construction, operations and maintenance
Local people should have a good degree of control in programme implementation, and the focus should be on appropriate techniques that can be operated and maintained using local resources. However, social/institutional constraints are not the only (or even primary) concern when building bunds – technical considerations are often overlooked. A few lessons learned are listed here which might apply generally:
 * The erratic nature of rainfall intensity and lack of good rainfall data meant that designing bunds based on certain assumed runoff coefficients was difficult - sometimes runoff was vastly underestimated, and this was the reason for 90% failure rate of earthworks during the first 2 years of a large bund building programme where high runoff flows damaged bunds. Stone bunds (if stones are available) would work better.
 * Undamaged bunds were related to catchment size – smaller catchments that were 4-5 times the size of the cultivated area were not damaged, whereas larger catchments caused bunds to be overtopped due to under-designed spillways. Smaller and more numerous catchments were therefore deemed to be preferable due to the reduced risk associated with them.
 * Bund height will vary from site to site, and is related to the slope of land and area to be inundated. The challenge is to size the field/bund area to ensure retention of enough water to carry a crop to maturity from one single flood, without making it susceptible to large unexpected runoff flows – e.g. in Turkana, designing bunds to allow 30cm of flood depth (as confirmed by local knowledge) or in India it meant a flood depth of 15cm.
 * Trapezoidal bunds work well in high rainfall intensity areas, and spillways around the edge worked better than spillways in the centre of the bund where erosional forces were concentrated. Even stone-faced spillways (as per Israeli design) were not always robust. Therefore type of bund has to be applicable to the local conditions. The exact shape of the trapezoidal bund varies in shape according to the terrain.
 * A few tips for construction of trapezoidal bunds: leveling the cultivated area within a bunded area is a good thing to do since it spreads flood depth evenly; a cut-off drain uphill of the bund allows high flows to be diverted if necessary, protecting the bund; trapezoidal bunds should be reinforced with stonework to counter erosive forces as this is the edge of the spillway in these bunds; low-tech leveling devices help uneducated people to be trained in designing their own bunds.
 * Bunds should be adequately compacted. If animals are used to create the bunds, they can help to compact the soil with their hooves. It also seems best to make bunds in the middle of the dry season so that they can settle under impact of human and livestock movement, in order to make them sturdy enough for the rainy season. Access to finance therefore seems to be important in allowing farmers to implement bunds. Due to the uncertain nature of flood events, it is important to plant drought-resistant (local) crop varieties in the fields which give better results.
 * In the site-specific case of artificial glaciers, the following methods are used: before the onset of winter, water is channelled from existing streams through 1.5” GI pipes into shadow areas of mountains close to villages. The water is made to flow out onto a sloping hill face where at regular intervals along the mountain slope, small stone embankments are situated to impede the flow of water which helps to create shallow pools. These pools freeze rather than infiltrate, but water is later released for crop irrigation prior to the usual time when snow melts on mountain tops. In this way, water is available more reliably for crops during a very short sowing season.

Maintenance
Stone bunds: There is limited, ongoing repair required as the stones are not vulnerable to erosion. However, silting behind the stone bunds requires that the stones to be relaid from time to time. Care must be taken that overtopping of the bunds does not lead to erosion on the downstream face, with subsequent gully formation and undercutting of the bund.

Costs

 * Where stones are in short supply, there are increased costs associated with their acquisition and transport.
 * Labour for construction: 6-16 days per hectare. Annual maintenance: 3-18 days per hectare.
 * If bunds are formed in a terrace-like design, the labour required for construction is estimated at 150 to 350 person days/ha for terraces and cut off drains. The cost of these structures is approximately $60-460/ha.

Manuals, videos, and links

 * Sourcebook of Alternative Technologies for Freshwater Augumentation in Africa or (alternative link). United Nations Environment Programme (UNEP), Division of Technology, Industry and Economics.


 * Water Harvesting: A Manual for the Design and Construction of Water Harvesting Schemes for Plant Production, FAO, Rome, 1991.


 * Water Harvesting Techniques, FAO: Natural Resources Management and Environment Department.


 * ARTICLE: Pre-flood warnings: Four bunds could develop breaches. July 9, 2011. The Express Tribune, Pakistan.


 * Large wiki on water use for agriculture: Agropedia

Acknowledgements

 * CARE Nederland, Desk Study: Resilient WASH systems in drought-prone areas. October, 2010.


 * Smart Water Harvesting Solutions: Examples of innovative, low cost technologies for rain, fog, and runoff water and groundwater. (or alternative link) Netherlands Water Partnership, Aqua for All, Agromisa, et al., 2007.


 * Rufino, L., Water Conservation Technical Briefs: TB 2 – Rainwater Harvesting and Artificial Recharge to Groundwater. Sustainable Agriculture Initiative (SAI). August, 2009.


 * Original Akvopedia article with more images: akvopedia.org/wiki/Bunds