User:1sfoerster/enes100/myWorkOnInkJetHack/button

/* InkJetEncoderCount Turns on and off a light emitting diode(LED) connected to digital pin 13, when moving inkjet printhead. This light is blurry, so added counter and serial port monitor output. The circuit: * LED attached from pin 13 to ground * one of the outputs of the inkjet encoder is attached to pin 2 created 2012 by Scott Foerster based upon the Button Example This example code is in the public domain. */

// constants won't change. They're used here to // set pin numbers: const int buttonPin = 2;    // the number of the encoder output is pushed into const int ledPin = 13;      // the number of the LED pin int Cnt = 0; //counting number of shadows

// variables will change: int buttonState = 0;        // variable for reading the pushbutton status

void setup { // initialize the serial communications: Serial.begin(9600); // initialize the LED pin as an output: pinMode(ledPin, OUTPUT); // initialize the encoder output: pinMode(buttonPin, INPUT); }

void loop{ // read the state of the encoder output buttonState = digitalRead(buttonPin);

// check if the encoder is HIGH. // if it is, the buttonState is HIGH: if (buttonState == HIGH) { // turn LED on: digitalWrite(ledPin, HIGH); Cnt++; // print the counter value: Serial.print(Cnt); Serial.println; }  else { // turn LED off: digitalWrite(ledPin, LOW); } }