User:Akshay.mistry/ENES-100/Poject 3

week 1
This week was spent figuring out the design of the pre-built Stirling engine, which is not working after many attempts. The goal is to figure out the issue thats preventing it from working. Here is the associated /CDIO/ page.

week 2
This week I dismantle entire engine in order to clean all the parts and joints and lubricate them in order to make it less frictional as possible, also used telfon tape in order to make complete air tight. Lots of other work was done during this week. Here is the associated /CDIO/ page

week 3
The Entire week was spent to re-run the engine with no lubricants around the power-piston. So, I used alcohol to clean power piston in order to make is completely oil free. And for the power cylinder I wash it with alcohol and reassembled entire engine back again. The power-piston was running with lots of friction,so then I put two drops of engine oil. And now the Stirling engine is running faster than before. Here is the /CDIO/ page.