User:Asmith6980/ENES-100/Project 1

Week 1 Narrative
To design a cavitation device using a plexiglass tube and stoppers and to design a vacuum that will cause the water to have a low-high pressure and essentially causing the collaspse of the bubbles created in the water. Also to design a device that will snap the water so no one is put in harm with snapping the tube. Check out my associated /CDIO/ page for more details!

My Second Task
To get the plexiglass tube cut down to 6 inches, and learn how to utilize an arduino. Also to learn the software of setting up the arduino to make the snapping motion.

Week 2 Narrative
To make the prototype of the tube that cavitation will take place in.

My Next Task
To discover how the arduino works, and attempt to get it hooked up to the solenoid.

Week 3 Narrative
Have the arduino hooked up to the basic blink template in the arduino software, and to mount the solenoid onto another part upside down in order to allow the snapping motion.

My Next Task
Creating a mounting block for the solenoid and a good suspension in order to create the snapping motion in the tube.

Week 4 Narravtive
To create the final CDIO page for project 1 and to explain to the next group the problem with cavitation and how to tie it into the water ram project.

My Next Task
To start project 2!