User:Drew Dollas/enes100/Glorious2/Batteryrecharge

1. Go into the Thunder AC6 settings on the dual power unit, and use the "Batt. Type" button to locate the USB and temperature settings. Turn on USB and turn off Temperature.

2. Load the CP210x USB to UART Bridge VCP Drivers (makes the USB look like a Com Port) https://www.silabs.com/products/mcu/Pages/USBtoUARTBridgeVCPDrivers.aspx

3. Load the logview software http://www.logview.info/cms/e_logview_info.phtml

Power up the charger, plug the USB in the computer and hopefully it will detect the new device and load the USB drivers..

Run the Log View Program select English

Select the DEVICE Bantam E-station BC6 charger.. select in DEVICE Open Port Recording

To start charging batteries using the charger -

1. Use program select to choose your type of battery

2. Change the amp and volt values on the charger to the voltage of the battery, and the recommended charge amps specified on the battery

3. Hold the start button

It should require you to hit start once more, and then it will start charging. It will show you the current voltage of the battery, the charging rate, and the time it has been charging. As it charges, if it is connected to the logview program, you should be able to see a graph forming. If you cannot, try changing the tabs below the graph from "Graph," to "Analog View" or "Digital View."