User:Givememyusername/ENES-100/Project 3/CDIO1

Problem
A mount that is transportable and that will not damage the door is required for the Knock Knock motor.

Required Materials
- 2 ratcheting straps

- Plywood

- 4 skateboarding wheels.

- 4 pairs of nuts bots and washers.

Required Tools
- Drill Press - Caliper

Assembly
Check your bolts to figure out the diameter that is needed for the drill press bit.

A drill press with a 5/6th inch bit was used for this mount.

The finished mount.

Finished mount with ratcheting straps on door.

Next Steps
-Solder input mic jack to wires

-Connect to Arduino