User:Gjaksec/ENES100/Tutorial

Steps
1) Draw the sleeve (the scuba material part which will vacuum seal to your forearm). Select the "cone object," and create it with its center   point at the origin of the left vertical plain.The cone's radius is 6cm, its angle is -30cm, and its length is 12cm.

2) Draw the brace that will secure the sleeve to the glove. Do this by selecting a cylinder object, and creating it at the center of the cone's base.  the cylinders radius must be 6.5cm, and its length must be 2cm.

3) Draw the glove piece, where the hand will be placed. Select the cylinder object again, and create it at the center of the brace's base.  The radius of the glove is 6cm,  and the length is 18cm.

4) Select the cylinder object and create it at the center of the glove's open base. The new cylinder's radius is 6.5cm, and its length is 5cm.  Next fillet the edged of the second cylinder by 2 cm.

5) The next step is to draw the hand grip. You won't be drawing the actual grip, but just the parts outside the Core Control glove.  Start by changing the view to the 'right side.'  Create cylinder: midway between the "top" and "bottom" of the glove section, and 3cm from the second brace that you made (reference the picture below). Make the cylinder's radius 1cm, and its length 24cm.  If the grip is not located at the right spot, just click and drag the object.

6) Draw the grip-to-tube connectors. Start at the center of either end of the grip, and create a cylinder: .5cm in radius, and 1cm long. Do the same to the grips other end.

7) Draw the water tubes. Starting again with either connector's center point, create a cylinder 1cm in radius and 12 cm long.  Next, create a box that is 2cm x 2cm x 2cm, with one of its side's center point at the tube's center point. Then, create a cylinder at the box's perpendicular side's midpoint, that is 1cm in radius, and 30 cm long. Create a box on the end of this cylinder as before, and create another cylinder off that new bow as before; this new cylinder has a radius of 1cm, and a length of 12 cm.  Repeat step 7 for the other connector piece.  Reference the drawing below for help.

8) Finally, create the water container. Start by creating a 35cm x 12cm x 12cm box anywhere, so that the 35cm x 12cm face is 'down'. Then, "Click and drag" the box so that it appears to be connected to each water tube (reference picture below).  Next, fillet the vertical edges by 6cm each, and the top and bottom edges by 12cm each.

This is the real version of the Core Control System: http://www.instructables.com/id/CoreControl-DIY/