User:Jesal.mistry/ENES-100/Project 1

=Stirling Engine= Stirling Engine is the process of burning engine where it use air on highly efficient thermodynamic design(cycle). For more information

week 1
Normally on this week researching about Stirling Engine. Then gather all require items which shows below. This is how Stirling Engine looks like

Requirement materials to assemble Stirling Engine
After done with different type of Stirling engine started to assemble Stirling engine. First put together all the materials which describe above. Here is my associated /CDIO/
 * 1) two empty Can(any 12oz) for the top can and displace cylinder
 * 2) Metal wire for the crankshaft
 * 3) Balloon for the diaphragm
 * 4) Soda bottle can for the diaphragm holder
 * 5) displacer
 * 6) M4 Nuts
 * 7) small washers
 * 8) M4 Bolts
 * 9) Disk for the flywheel

week 2
This week was spent on making loop screw with specific measurement. A displacer was also made out of wood. Loop screw made of hard metal on which thread was made by a die tool so that loop screw can perfectly feet on the Dis-placer. Also spent on time to make Double Loop Rod from Kebab skewer which hep to connect dislacer to Drive shaft(crank shaft).

week 3
On this week working with Ryan, and Akshay to make stand of Stirling Engine. The tin was extra long so cutting job was done to make it half of it's original size so sterno flame could reach in the bottom if the Engine.

week 4
After complete the final stirling engine stand. Made 2 inch diameter of circle hole. cutting job done by cutter. so the flame can directly heat up the lower chamber of Stirling Engine. Also made eight hole at top of the stand. so flame can get enough oxygen. Then finally done all modification job, tried to make run Stirling engine by given heat at bottom chamber. associated /CDIO/