User:Kdhakal5654/ENES-100/project 3

Week 1 Narrative
Task Create Schematics for the processing inside our Room Access Mechanism and set the mount in place.

What was done My partner who's task involves all the programming for the Room Access Project drew out the drawing as a rough sketch,and then that's what was drawn on Google Drawings. The Mount that I had ordered did not fit with the hook on the back of the monitor.

The screws were not aligned so my solution was to put a thing block of wood between the mount and the back of the monitor. I can then screw both pieces into the wood and hold them together.

The drawings are:

Next Steps

- More Schematics

- Certified to use a drill press

- Screw Monitor and Hook onto the wood.

- and possibly mount it on the wall if the location is approved.

Week 2 Narrative
Task- Find a place to mount monitor, and to draw more schematics

Doing- I taped a spot next to the door and then i placed the mount, so that I could outline where to drill holes. Since the mount can move back and forth, I didn't want it in a place where it would get in the way of something or prove to be hazardous. I also found a new and stronger block of wood to place between the back of the monitor and the mount. Regarding the Schematics, I need more questions answered on the software of the Room Access project.

Next Steps- -draw schematics -drill holes on the block of wood -mount the monitor

Week 3 Narrative
Task- Create Schematics, set monitor on wall.

Doing- I asked a few questions related to our project with my partner and I created a Schematic based off of the questions. The schematic that I had drawn from these questions was what i think the answers portrayed.
 * 1) What instructions does the Arduino give to the motor?
 * 2) What messages occur between the motor Shield and the Arduino?



In order to Mount the Monitor, we had to pick a spot next to the door. We chose this spot we did not the monitor to come in the way of anything. The Monitor would be in a high place where it will be tilted a little bit downwards to show the Information once Arduino accepts the Barcode.



Next Steps-
 * I passed the Drill Press Quiz so now I can wait to be approved to use it.
 * More questions and more Schematics.