User:Kshew12/ENES-100/project 2: BioFeedback/Tutorial on recharging LiPo 3.7V 1000mAh Battery

How To Recharge LiPo 3.7 1000mAh Battery
Purpose: To show other engineering students how to recharge LiPo Battery

Materials:
 * Lithium Polymer Battery
 * Aligator clips
 * Thunder A6 Charger
 * Wires to connect battery to charger

Instruction
 * 1. Plug in the power cord of Thunder A6 charger to an outlet and turn it on.
 * 2. Click the red button "Battery Type/STOP" to select the LiPo battery and then click the green button "Start/Enter"
 * 3. On LiPo setup screen, adjust charging current and voltage using blue "dec" and yellow "inc" and hit the green button when you are done. [For 3.7V 1000mAh battery, set Volt as 3.7V and Amp as 0.2A]
 * 4. Connect conducting wires to LiPo battery.
 * 5. Connect LiPo battery to Thunder A6 Charger using alligator clips
 * 6. Hold green button for about 3secs then you will see "Battery Check" screen, if the information you provided to the charger corresponds to the battery then confirmation screen will pop up
 * 7. Hit green button once more on confirmation page to start charging.