User:Mkamara9540/ENES-100/project 3

pictures from soldering
These are the videos of the soldering process

The setup
https://www.youtube.com/watch?v=w-fHXQaj690&feature=youtu.be this is the link for the setup

problem 1
https://www.youtube.com/watch?v=amb-bQePVdw&feature=youtu.be link of the struggle to line up the wire to the spot where we want to solder

problem 2
https://www.youtube.com/watch?v=I3DKxx5IRz4&feature=youtu.be part 2 of the struggle to have the wire steady to the soldering spot

frustration 1
https://www.youtube.com/watch?v=qPV2QwJB_XA&feature=youtu.be link of the frustration of the soldering not working properly

new plan
https://www.youtube.com/watch?v=Nrg1fDJraJ4&feature=youtu.be link of keeping hands away from hot solder

frustration 2
https://www.youtube.com/watch?v=00cyYkTInuI&feature=youtu.be link of frustration and new plan to solder without the wire moving

failure
https://www.youtube.com/watch?v=AiJ1Y60ykVE&feature=youtu.be link of constant failure of soldering

success
https://www.youtube.com/watch?v=kAkFFswqNpQ&feature=youtu.be link of success of soldering

Next Steps
is to set the broken CAN bus (cut terminating resistor) as the transmitter to see if that will help eliminate the problem

task
 File:Good CAN bus.JPG | good can bus

File:Bad terminating resistor CAN bus.JPG|CAN bus with a bad terminating resistor

File:Windshield wiper motor.JPG|windshield wiper motor

File:Car seat.JPG|car 'seat with a seat belt sensor

File:Jetta ECU.JPG|Jetta's ECU

File:Wiring harness module box.JPG|harness module wires (CAN bus inside)

File:CAN bus Electrical diagram.JPG|CAN bus diagram 

https://www.youtube.com/watch?v=MCHTsKVzi2k&feature=youtu.be Video link of CAN bus and ECU powering up the OBD connector

Next Steps
check condition of the harnesses and see if anyone burned out

check for any blackened wires, melted plastic and smell

use OBD connector to find problem on the jetta ECU

task
getting prepare for the presentation

next steps
find CAN bus in the car seat

use the OBD scanner to detect problem on the CAN bus (car seat)

task
-do the cad drawing

-come in during the to work on the project ( CAN bus)

DOING
 File:Arduino uno CAD.png|CAD drawing of arduino uno 