User:Pnguyen6224/enes-100/project 2

My Instructor's user page which points to this.

Week1 Narrative
My Task: to make a 3D model of the TV mount in Autodesk Inventor

What got done:
 * made the back pieces of tv mount
 * made the arms
 * made the front piece
 * made different size joints
 * started on assembling the 3D pieces

Next Step:
 * make the 3D model of actuator
 * attach the actuator
 * Finish up the assembly file

Week2 Narrative
My task: What got done:
 * To continue working on assembly file
 * make actuator

 File:Arm Piece.png|this pieces connect to the pack piece and the other arm piece File:Arm Piece 2.png|This is the arm Piece that connects to the front piece on the back side File:Short Joint.png|A small joint File:Mid Joint.png|middle length joint File:Long Joint.png|A long joint File:Front Piece.png|front view of the front piece where you mount the Tv File:Front pieces.png|back view of the front pieces File:Back Piece.png|Back Piece 

 File:TV mount.png|this is the complete assembly of the TV mount 

 File:Linear actuator.png|linear actuator 

Next step
 * Show how it work by filming
 * Add in actuator to TV Mount

Week3 Narrative
My task: What got done:  File:Tv mount.png|this is the TV mount and the actuator File:Actuator position 2.png|this is other idea of where the actuator should go File:Tv Mount.png|Tv Mount with the actuator attach 
 * film the movement of 3D model of Tv mount
 * figure placement of linear actuator

Here is a video of how the TV mount will move with the linear actuator

Next step:
 * figure out where to use pulley system
 * test wood model of actuator once build
 * test both ideas

Week4 Narrative
Task:
 * to redo video
 * get measurement of tv mount movement

What I did:


 * Here the redo video
 * max length: 7 in.
 * min length: 5 in.