User:Ramiseif7/ENES-100/project 1/CDIO

Designing the Implementation Process
Starting point /DC Motor Control Tutorial// to run the motors.

Power was tested by holding on to the gears of each motor.

If the motor stopped when held, it was proven to not have sufficient power.

Stepper motor was only motor that proved to have sufficient power

Test, Verification, Validation, and Certification
Tests were run using the /arduino/ software All DC motors ran off of straight power without use of a software Stepper motor test was used for the Stepper Motor

File-> Examples-> Motorshield-> Stepper Test-> Upload test was compared to that of this /video/ Speed was changed around to test different speeds

Videos were taken to show the Motor in use This /video1/ shows the Stepper Motor running straight off a 9V power supply This /video2/ shows the stepper motor running when the 'stepper motor test' was used on the Arduino software (same test conducted for the first video used for comparison).

Poster