User:Ramiseif7/ENES-100/project 3/CDIO

Problem Statement
Starting Point: One of two quadcopters was flying. The one that wasn't had a broken frame that needed to be fixed. First we took apart the quadcopter down to the frame itself to fine the whole frame was cracked. Superglue was used but did not dry quickly We found a giant clip to hold the frame together overnight New Objective: Attach a set of wheels to the bottom of the copter so when not in flight, it will drive

Designing the Implementation Process
A team before us designed a crosshair guard for the frame we wanted to replicate to put on both sides of the frame. the design of the piece was found at www.thingiverse.com/thing:8001

After frame was reattached both guards were attached connected by screws

Took apart small toy car so all that was left were the wheels and the electronics. Then used superglue to attach a thick 2.5 x 5.1875 piece of cardboard to the top as a medium base for the copter and the wheels. Pictures were taken

Poster






Next Steps
Next is to figure out how to dissasemble a type of nerf gun and attach it to the copter and get it to shoot while flying