User:Ryan Decker/ENES-100/Project 1/Mount Replacement

Problem Statement
One of the screws in the quadcopter is coverd in a peanut butter like substance.

Training and Operation
The screw was cleaned using a grease removing soap and a cloth with just enough removed s the screw could be unscrewed and more thoroughly cleaned.

Next Steps
No further action needs to be taken now the screw is clean.

Problem Statement
The propeller mount for the AR drone has broken in half and needs to be replaced with a new propeller mount

Training and Operations
The broken propeller mount was removed from the quadcopter, dissassembled, replaced with the new propeller mount, then reassembled in the quadcopter. Steps are in the Poster. While replacing the propeller mounts it was discovered that several of the screws had been stripped making the process of replacement increasingly difficult. On one of the screws there was a peanut butter like substance which prevented the screwdriver from being used on the screw until the substance was cleaned out of the screw head. The way the wiring was bent in order to be attached from the mount to the moters so to remove it a pair of tweezers were needed to grasp the sides of the wiring to wiggle it out of it's connection.

Next Steps
This action will be performed on the other quadcopter to replace it's cracked propeller mount.