User:Shengtaoliu/ENES-100/project 3/CDIO

Problem Statement

 * The ICV valve need to be replaced because the room inside the ICV valve is too small.
 * How to use the 3D tin the draw the ball valve; and use the 3D printer to print it out.

The Initial Design Process

 * Tried to use the ICV valve.
 * Make a charger for ICV valve.
 * Tested the charger's wires and ICV's wires for Live Line and Neutral Line.Switched these 2 wires to test. Found out no matter connect Live Line(Hot Line) or Neutral Line, always a click sound when charger's cables and pump's cables touched.
 * Used the Anderson connector to connect charger's wires and ICV's wires first, then connected them together.

Operations

 * Cut the cable off.
 * Peel the wires.
 * Test the wires for Live Line and Neutral Line. There is a click sound if the charger's wires and ICV's wires are connected.

Use 3D tin to draw ball valve

 * The model of the ball valve.
 * Draw the hemisphere, pipe.
 * Combine hemisphere and pipe.


 * Found out thisvalve

Next Steps

 * Follow the valve
 * Keep drawing in 3D tin.