User:Srokebep/ENES-100/project 2/CDIO

=Implement=

Hardware Manufacturing Process

 * Order parts
 * 5 x 1-1/2" PVC Compression Coupling
 * 1 x 1-1/2" PVC Pipe
 * 3 x 1-1/2" 45-deg PVC Elbow
 * 1 x 45-deg 3/4 PVC Elbow
 * 3 x SAKRETE
 * 1 x 1-1/2 x 1-1/4 Reducer
 * 1 x 1-1/4 x 1 Reducer Bushing
 * 1 x 1 x 3/4 Reducer Bushing
 * 1 x 3/4 x1/2 Reducer Bushing
 * 3 x 1" x 10' Galvanized Steel Pipe
 * 1 x valve

little problems and fixes
a) cap off bottom of PVC
 * 1) p) base bucket's PVC sleeve filling up with sakcrete

a) mark each leg with colors or numbers so they can go back to where they were first drilled a) prep bottom of bucket with sand paper and be sure to use primer
 * 1) p) after drilling holes for support pins hole don't match
 * 1) p) hard to glue PVC to bottom of reservoir buchet

Measurement
This is for the base PVC on bottom of reservoir bucket should be placed every 10.47" at a 24deg angle