User:Stivi10/ENES-100/project1/CDIO page

Rube Goldberg Project
Develop a Rube Goldberg machine with a specific and obvious theme.

Conceive
The decision was made that the theme of the Rube Goldberg machine will be /superheroes/. The job of each superhero in the machine will correspond to their powers. Must of the Rube Goldberg machine will be powered by gravity and various mechanical "systems." --MikeBertrand6 (discuss • contribs) 22:52, 12 March 2013 (UTC) --Stivi10 (discuss • contribs) 22:14, 12 March 2013 (UTC)

Design
At the end of conceive part, it was decided that 6 steps would be designed. For the first step click here. for the second step, nothing particular was done here because there was not enough time. However an it was decided that the road should have boundaries so that the car will not fall after it is hit by the superhero. Also, the distance the car should traveled before it hits the superhero should depends on how long the car can travel.For Step 3 click here. For the step 4 and 5 click here. For step 6, The pulley, and the cord were furnished, so the trap was made, and unfortunately broken. (Refer to the tutorial below to see how it could be made.). Also, it was decided that for the last step a villain moving back and forward could be cached by the trap right at the moment it falls.

Tutorials
Fot this project the Electromagnet, the Basic Pullet, and the trap (that has unfortunately been broken before any pictures could be taken.) were done. --Stivi10 (discuss • contribs) 19:08, 14 March 2013 (UTC)