User:Tknbeez/ENES-100/project 0/CDIO

Problem Statement
To build a motor of the Ball Drone strong enough to make it fly with controllable speed. Parts of a half-built Wind tunnel could be good materials to start with

Designing the Implementation Process
The motor should be in the middle of the ball drone and it should look like this [Ball Drone design]

Work flow
Trying to see which parts of the Wind Tunnel to take out and use for the motor. The problem is the parts and wires are completely attached and connected together so it looks really messy and complicated. It's difficult to find out where to start

Test, Verification, Validation, and Certification
When it is done, it will be tested to see if it can fly stably in long distance and hours, the speed is controllable, the camera successfully records image and videos and finally if the drone could land without any damages. Pretty much like this video [Japanese Ball Drone tested]

Next Steps
Take off the Fan Try to connect with a smaller motor that will fit the Ball Drone Find out how to write a program to make it works