User:Tknbeez/ENES-100/project 1/CDIO

Problem Statement
To build a motor of the Ball Drone strong enough to make it fly with controllable speed. Parts of a half-built Wind tunnel could be good materials to start with

=Implementation= The motor should be in the middle of the ball drone and it should look like this [Ball Drone design]

Materials
Trying to see which parts of the Wind Tunnel to take out and use for the motor. The problem is I accidentally separated the parts and couldn't get it to work. I tried looking up the previous works to fix my mistake. However after doing what I think is exactly the same as the previous work from the previous teams, I still couldn't get the motor to run. The work done so far is showed in posters. Summary of what I did so far - Connect the wires from the arduino and the speed controller which have the same color together ( black to black, red to red, white to white) - Connect the red wire from the speed controller to the 12V black plug on the power source _ Connect the black wire from the speed controller to the 6V red plug on the power source

Test, Verification, Validation, and Certification
When it is done, it will be tested to see if it can fly stably in long distance and hours, the speed is controllable, the camera successfully records image and videos and finally if the drone could land without any damages. Pretty much like this video [Japanese Ball Drone tested]

Next Steps
Fix my mistake or try to make it work again Figure out how to apply the process of the wind tunnel to build a similar fan motor inside the ball drone Find out how to write a program to make it works