User:Tknbeez/ENES-100/project 3/Week2 CDIO

Problem Statement
Open up the ball bot to see if there's any problem inside

Designing the Implementation Process
Removed the 6 screws on the hip of the ball bot ( 3 from each side). Pull off the hip from the back in opposite direction to open it up.

Saw that there's a chip inside the hip with a lot of wires.

Some wires are connected to the hip, some go downward to the legs and some go upward to the chest.

It seemed that the wires are in perfect condition, nothing is disconnected or unplugged.

However there was a little dust on the chip. Clean it by blowing into it and brushing it.

Activated the ball bot again, still didn't work. Checked and compared the old document and found out that the wires are connected the right way. Nothing is wrong. So there's probably no problem on this part.

Implementation Management
Next step is to find out a way to open the legs and take off the damaged screw