User:UsKhalid/ENES-100/project 2/Week1 CDIO

Problem Statement
To do the wiring of the Arduino and get the Ball Bot to work.

Designing the Implementation Process
The Ball Bot was not working at all. There was no arduino. The arduino had to be attached. The wires were new, like untouched. In order to plug them into the arduino, lead from the resistors was used, which made i easier to plug the wires. A lot of resister were thrown away in this process.

After the successful plugging of the wires into the arduino, now it was the time to upload a program to the arduino to test it. The program used to test the Ball Bot was the program provided by the instructor and it was taken from here.

Test, Verification, Validation, and Certification
This video shows the Ball Bot spinning around. By tapping on the head of the Ball Bot, the program started. The Ball Bott started to move. This video shows how the Ball bot worked.

Next Steps
The next steps would be:
 * Getting the led lights of the eyes and mouth to work
 * Getting the head of the Bot to open on its on and the light of the head to work
 * Getting the ears of the Bot to come out and light up
 * Programming the Bot to do different stuff.


 * This video shows how the ears of the Ball Bot come out and how the head pops up.