User:Wsnyder0080/ENES-100/project 3/week 2 CDIO page

Problem Statement
Design a part of a rube goldberg machine

Requirements for each element or component derived from system level goals and requirements
The requirements for this project are the part must be able to hang on a wall, it cannot use fire water or guns and must be small

The initial design
My design is to have a strip of wood that both hammers will attach to with a hole drilled in the middle where 1/2" PVC pipe will go through and act as an axle. there will be a hole drilled at both end of the handles of the hammers where bolts will hold them to the central piece of wood.

Next Steps
obtain the hammers and build the part