User:Wsnyder0080/ENES-100/project IWCC/week 2 cdio page

Problem Statement
in order for an airsoft tank's turret to be mount to the boat; it will need a new cover plate for the top of the boat.

Requirements for each element or component derived from system level goals and requirements
The new cover plat must be flat and provide a good mounting point for the turret. it must be strong enough to support the weight of the turret yet lightweight enough so that it won't cause stability problems. it must also be able to keep water from getting in the boat

Alternatives in design
I will use the existing cover plates attachment mechanisms.

The initial design
My design is made out of 1.5mm plastic stock with 3/8" angle iron plastic stock to form a lip on the bottom

prototypes
one of the problems found was that with the new cover plate the front attachment hook was too long so it had to be shortened by 1/8"

Next Steps
attach the rear attachment hook to the new cover plate and mount the turret on the cover plate