User:Yonatanadane/enes-100/project 1

My Instructor's user page which points to this.

My task was
My task this week was to :
 * Do a knowledge understanding on turbine parts.
 * Figure out the physics of turbine.
 * Do a knowledge based understanding on the engine turbine.

What I did

 * Found Wind turbine tutorial.
 * Found Wind turbine video]

Proposed next steps

 * Find how we can work with the parts we have.
 * Find out if the gears are going to work for us if not find some other solution.
 * Measure the diameter of the gears it can help us on the project.
 * figure out what formula we have to use while doing these project.

Week2 Narrative
My task this week was to :
 * Do a knowledge base understanding on jet spec
 * Post picture of previous projects.

What I did

 * The flame tube have a inducer diameter of 2.9inch.
 * There are three parts were the tube is drilled, primary, secondary and Tertiary.
 * primary holes have a diameter 0.25inch and 40.368holes, secondary holes have a diameter of 0.375inch and 11.9holes, and tertiary holes have a diameter 0.625inch and 10.8 holes.
 * Flame tube length 17.4inch, and diameter 5.8inch

Proposed next steps

 * Relate Previous project with current project.
 * Do a spec for the current project

My task was
My task this week was to :
 * Relate Jet spec app with current project
 * Fit the nozzle of the turbine with the fan.
 * post before and after picture of the nozzle and fan.

What I did

 * Found the jet specs app the link to the website is http://www.nuclearprojects.com/jetspecs/. This website have a flame tube calculator. It let choose the unit we intend to do the calculation. Enter the inducer diameter we want. It calculate the appropriate length of flame to use and the number of holes on the three part of the flame tube. i.e primary,secondary, and tertiary. Here is the link to an example of an example. http://www.nuclearprojects.com/jetspecs/flametube.php.
 * Unfortunately the current project doesn't have a flame tube but the jet spec app can be helpful in determining the combusator housing.
 * Post previous project jet spec

Proposed next steps

 * Measure the diameter of the inducer diameter, so its able to calculate the combusator housing using the jet spec app.
 * Fit the fan on the turbine.
 * Prepare for presentation.
 * Make sure the fan Fit with the intended tube.

My task was

 * Mainly focus on the team page
 * Start presentation

What I did

 * Figure out what my push points were for and post them on the project page
 * Gather data to put on the presentation slides.
 * found a video that justifies how turbine works. http://www.youtube.com/watch?v=p1TqwAKwMuM
 * putted push point on the team page.

Proposed next steps

 * Work on presentation and try to present by Tuesday.
 * Brain storm with the team about next project.