User talk:Shengtaoliu/ENES-100/project 1

What ohm of shunt resistance for converting voltmeter to ammeter?(1ohm or<1ohm) Where to place the shunt resistance in voltmeter?(should be in parallel connection)

CDIO page is a great start. I edited it.

Do not use the word "Research". It lowers engineering respect. It implies you don't know something.


 * video is great
 * two diagram links are not .. I am deleting them

Link to a pdf file is great .. follow it.

Where to place the am meter in the tester? where am4 or am5 are in the simulation at circuit lab ...

I deleted the knowledge section ... no meat in it ...

Continue taking pictures!

10/10/30 ... --1sfoerster (discuss • contribs) 22:04, 25 February 2013 (UTC)

The design page needs descriptions (draw circuits in circuit lab) of what you are trying to do and what is not working. Focus on describing the problem, not figuring out the electronics. What exactly are you trying to do? Where are you planning on putting it in the circuit? What is the range of current at the spot in the circuit ... what does it map to in terms of the circuit loading a power supply? .... Pictures are good, but there is not a starting point of a conversation yet.

10/10/15 ... --1sfoerster (discuss • contribs) 20:26, 5 March 2013 (UTC)

10/10/50 ... great job .. put all of your pages together into one CDIO page ... it is too fragmented right now ... --1sfoerster (discuss • contribs) 14:32, 12 March 2013 (UTC)

10/10/30 ... good job describing failure ... I was able to pull out of this something useful ... --1sfoerster (discuss • contribs) 14:01, 28 March 2013 (UTC)